A Job for the Dremel

Cynthia is fascinated by my Dremel tool, and seems to think it can tackle any job -- not true, of course, though it is quite versatile. It was the right tool for this job -- cutting off the excess length on the bolts attaching the bed rails to the posts. It didn't take long for that paper-thin disc, spinning at 25,000 rpm, to cut through them.

I could have used a hacksaw if I'd done the job before assembling the frame, but it would have been awkward trying to hold the post steady, and not nearly as much fun as seeing the little stream of sparks flying off the cutting disc.

Made a nice change from painting.